Epson TM-T88V-DT Benutzerhandbuch Seite 18

English
Removing the Jammed Paper
When a paper jam occurs, never pull out the paper forcibly. Open the roll paper
cover and remove the jammed paper.
CAUTION:
Do not touch the thermal head and the frame on its side (indicated in the circle
in Illustration
If the roll paper cover does not open, follow the steps below.
1. Turn off the printer.
2. Slide the cutter cover toward the front to open it. See Illustration S.
3. Turn the knob until you see a triangle in the opening. This returns the cutter
blade to the normal position. There is a label near the cutter to assist you. See
Illustration T.
4. Close the cutter cover.
5. Open the roll paper cover and remove the jammed paper.
Controlling the Speaker Volume
You can control the speaker volume with the speaker volume control on the
operating system on the computer.
Changing the Orientation of the Optional Customer Display
Hold the main body with your hand and move the optional customer display to
change the direction or angle. Make sure to move it in their mobile range only.
CAUTION:
Do not rotate the customer display with excessive force. Doing so may break
the customer display.
The mobile range of the display is as follows. See Illustration U.
❏
Display tilt (U 24):
❏
Display rotation (U 25):
❏
Arm rotation (U 26):
Securing the Product
You can secure the product to the installation surface with optional affixing tape
(hook and loop fastener, Model: DF-10), following the steps below.
1. Place the product so that you can see its bottom.
2. With two pieces of the affixing tape combined, peel off the backing paper of a
pair on one side, and paste it to one of the specified positions on the bottom of
the product. Illustration V shows the affixing tape positioning lines (V 27)
and the positions to paste the affixing tape (V 28).
3. In the same way, paste other three pairs of tape in the specified positions.
4. Peel off the backing paper of each pair on the other side of the affixing tape,
turn over the product back on its bottom, and place and secure it firmly to the
installation surface.
Security Hook
You can attach a commarcially available security wire to the security hook (W 29).
10 TM-T88V-DT User's Manual
R
) because it can be very hot after printing.
Maximum angle of 48
Maximum angle of 300
Maximum angle of 270
(4 levels, 5 positions)
°
°
(L-shaped pole only)
°