CareFusion MicroLoop Betriebshandbuch Seite 28

Press 'Again' to repeat the calibration
check (verification) at a low flow rate.
Press 'Again' to repeat the calibration
check (verification) at a high flow rate.
When a calibration check (verification) at
all three flow rates has been completed
press 'Done' to view the calibration check
(verification) report screen.
The calibration error for expiration and
inspiration at
displayed. The calibration error should
be less that 3%.
shown, repeat the procedure ensuring
that the syringe is emptied and filled in a
smooth manner
handle. If an error greater than 3% is
still shown, inspect the turbine transducer
and clean if necessary.
26
each flow rate
If a greater error is
without jerking
are
the