Maintenance; Ordinary Maintenance; Special Maintenance; Disposal And Scrapping - Nitty-Gritty clinox power Bedienungsanleitung

7. MAINTENANCE

Pay attention: before any maintenance it is necessary to disconnect the machine from the mains.
7.1. O
RDINARY MAINTENANCE
Before every work shift:

Check the condition of the machine's components and replace them if necessary; use only original parts.

Check the condition of the electrical equipment and value its reliability during operation.
At the end of work shift clean the machine:

Remove the pad/brush (28/32/36/46/49/51) from the insert (16/27/35/48) of the torch to prevent encrustations of the
electrolyte on the tip due to evaporation and corrosion on the electrode. Whenever the pad/brush (28/32/36/46/49/51) is
worn or burnt, replace it with a new one before restart working. If the pad/brush (28/32/36/46/49/51) does not require
replacement, rinse it out with water.

Once it has cooled down, clean the insert (16/27/35/48) and tip of the torch to prevent encrustations.
Pay attention: N
ITTY
7.2. S
PECIAL MAINTENANCE
Extra-duty maintenance is generally effected by qualified technical of N
Pay attention: the N
ITTY
authorized people.

8. DISPOSAL AND SCRAPPING

Pay attention: the user must pursue the maximum environmental protection.
P :
ACKING this kind of waste is similar to the urban kind. It is therefore possible to dispose of it in the urban refuse disposal
sites without jeopardizing the environment or the population.
U :
SED SPECIAL PADS
D
ETERIORATED OR OBSOLETE MACHINERY
Special waste to be scrapped according to the machinery. With reference to the CE-2002/96 directive concerning
waste of electric al and electronic equipment (WEEE), during dismantling, the user must separate the electrical and
the electronic components and dispose them in the appropriate authorized collection centers or give them back as
they are to the seller, when a new purchase is made.
W L :
ASTE IQUID
during the process (cleaning and polishing) heavy metals are mixed with the waste liquids: thus the liquids
have to be considered as special waste and disposed following the regulation in force in the country where the machine is used.
9. DECLARATION OF CONFORMITY: CE - R
N -G
ITTY RITTY

Directive concerning Machines 98/37/CE and succeeding amendments.

Directive concerning Low voltage 2006/95/CE.

Directive concerning Electromagnetic Compatibility 2004/108/CE.
and to the following harmonized regulations:
DIN EN ISO 12100-1, DIN EN ISO 12100-2, DIN EN 60204-1, EN 55011, DIN EN 61000-6-4, DIN EN 61000-6-2,
EN 61000-4-2, EN 61000-4-4.
 Directive 2002/95/EC (RoHS) - concerning using restriction of six specific dangerous substances (Cadmium, Mercury,
Lead, Hexavalent chromium, Polybrominated biphenyls - PBB, Polybrominated diphenyl ethers - PBDE) in electric
and electrolytic equipment sold in UE.
Spilamberto, 01/2014
CLINOX POWER
-G is not liable for the consequences if other products are used.
RITTY
-G guarantee will fall if the product is dismounted repaired or in any case handled by not
RITTY
the disposal of special waste must be in compliance with the regulations in force.
:
declares that the weld-cleaning machine meets the following directives:
-G or authorized centers.
ITTY RITTY
HS
O
Technical Director
44
Michele Lapelosa