Dometic CS 110 Bedienungsanleitung Seite 8

Installation
Please follow these installation instructions:
For best performance, air needs to circulate freely over
the cooling unit behind the wine cellar. The free-stand-
ing design of the cellar means that it should stand at
least 25 mm from the rear and side walls.
Allow a clearance of at least 100 mm above the wine
cellar.
Adjust the feet of the wine cellar so that it stands in a
vertical position in both directions. Use a spirit level if
necessary. FIG.1
1. Remove the transport pallet on which your wine
cellar rests.
2. IMPORTANT ! Adjust the feet to allow a 30mm
clearance under the wine cellar
3. Attach the distance bar using the two screws at the
top back on each side of the cellar. The rod ensures
the correct distance to the wall behind. FIG 2,FIG4.
4. For optimum performance, please place your wine
cellar far away from any source of heat
(radiator,cooker or intence sunlight) .
FIG 2
8
FIG. 1
Distance bar
Distance bar
Rear
5. Check that the charcoal filter is in place at the top
left corner inside the wine cellar.
6. Fit the door handle to the door. The door frame has
pre-drilled holes on its side(s). FIG 3
Please note that it must be possible to open the
wine cellar door at least 90° to allow the sliding
shelves to be pulled out.
* IMPORTANT WARNING !
7. Attach the driptray on the back as shown on the
pictures FIG 5a , 5b , 5c. on page 9. The screws are
already attached at the back.
FIG 3
30 mm
Wall
25
25
Wall