Dometic CS 110 Bedienungsanleitung Seite 10

You should replace the inside ventilation charcoal filter
every second year. The filter is fitted in the upper left
corner inside the wine cellar.
If the wine cellar fails to work, check the following
before calling a service technician:
•
that the fuse of power supply is intact
•
that the plug is properly inserted in its socket
•
that the wine cellar is switched on
If the cause of failure is not listed above, an authorised
service technician must be called for.
The wine cellar is equipped with overheating protection.
An authorised service technician can check whether
this has been triggered or not.
Storing the wine
Please see illustrations on pages 31-32.
Bottles should be stored in your wine cellar according
to their size. The most known bottles are the "Bor-
deaux" and the "Burgundy". These bottles are not all
identical. The most widely recognised bottles are the
"Tradition" and the "Légère". The "Champenoise" and
the "flûte d'Alsace" bottles have different diameters and
heights. Take these differences into account when
storing your wine and avoid mixing the bottles.
It is important to store bottles on their side in order for
the cork to remain in contact with the wine. Place
bottles top to bottom in the cellar for optimum volume
use. Our illustrations show the best way to stack the
"Burgundy" and the "Bordeaux Tradition".
NOTE that you should store no more than
one layer of bottles on the sliding shelves.
The sliding shelves and the storage shelves can be
placed in several positions depending on the size of
your wine cellar. FIG 8 & 9
10
Model
CS 110
CS 160
CS 200
Each kit contains two shelves and shelf supports.
Sliding shelf kit number: 921 17 81-99
Storage shelf kit number:921 17 81-98
The maximum number of Bordeaux tradition bottles that
can be stored in a wine cellar that is fitted with storage
shelves and one sliding shelf:
Model
storage shelves
CS 110
CS 160
CS 200
Installation of guides and shelf
supports
Installing guides for the sliding shelves by placing
the rear hook of the guide in front of the desired hole in
the rear row ( Arrow 1 FIG 8 ) push in the direction of
the arrow. Then do the same with the front hook (Arrow
2 FIG 8) .
FIG 8
Installation of shelf support for storage shelf. Place the
support hooks in the holes at desired level, press in as
arrow 1 indicates and push down as arrow 2 indicates
see FIG 9
FIG 9
NOTE ! The reinforcement bar is a shelf support
and must not be removed for safety reasons.
Reinforcement
bar
Max. no. of
sliding shelves
8 woodendoor / 9 glassdoor
12
16
No. of No. of bottles
1+1 116
1+2 170
1+3 206
1
2
1
2