Stihl FW 20-TS 410 Gebrauchsanleitung Seite 9

4
3
Lower the tube (3) and at the same
N
time lift the locking lever (4) to the
raised position
Holding the tube firmly down, press
N
down the locking lever and engage
it on the handlebar.
Mounting the throttle control
2
2
2
1 1
2
2
2
Twist off and remove the knob (1)
N
on the lever which controls the
cutting depth adjustment
Unscrew the screws (2) and remove
N
the half of the housing
FW 20 - TS 410, TS 420, TS 480i, TS 500i
Replacing the carrier
3
Carriers (3) with only one hole must
N
be replaced with carriers (4) from
the attachment kit
Mounting the throttle cable
2
Guide the throttle cable nipple (5)
N
and screw sleeve through the
support (6)
Screw on hex nut (7)
N
Nest the throttle cable nipple in the
N
holding hole (B)
4
5
7
6
Adjusting the throttle cable
8
Set the bracket bow to the full-
N
throttle position
Tension the throttle cable with the
N
lower nut
until the lever (9) rests against the
end-stop – the throttle cable must be
located in the guide, with the throttle
lever in the full-throttle position
Tighten up the hexagon nut (8)
N
Release the bow – Idle position –
N
The cut-off machine throttle lever
must be in the idle position
Readjusting the throttle cable
When the cut-off machine is mounted,
the throttle cable can be readjusted if
necessary.
English
9
7