Stihl FW 20-TS 410 Gebrauchsanleitung Seite 8

English
Cut-off Machine Cart
+
+
A basic machine and an attachment kit
are combined to produce a complete
cart FW 20.
The complete instruction manual for the
cart FW 20 therefore consists of two
instruction manuals – one for the basic
machine FW 20 and one for the
attachment kit FW - TS.
Always read both instruction manuals
carefully before using your machine for
the first time and keep them safe for
future reference.
Additionally, observe the instruction
manual of the cut-off machine used.
6
Mounting
Mounting the support
1
2
Raise the tube (1) to the up position
N
Insert screws (2) M8x25 from above
N
through the oblong holes in the
support (3)
Position the support (3) so that the
N
notch (4) in the upper oblong hole is
centered in relation to the screw
Screw on and tighten the hex nuts
N
with washers
If the support cannot be installed:
N
Rework the frame of the cut-off
machine cart STIHL FW 20
Mounting the cut-off machine
2
1
Position the cut-off machine so that
N
the pins (1) protrude into the holes
in the support (2)
Aligning the clamping plate to the guard
A
Outer mounting of the guard
Mount the clamping element in
N
position A
Inner mounting of the guard
Mount the clamping element in
N
position B
FW 20 - TS 410, TS 420, TS 480i, TS 500i
2
1
B