Climma COMPACT QUATTRO Bedienungsanleitung Seite 12

7 - TROUBLE SHOOTING
6 - TROUBLESHOOTING
Before calling an Assistance Centre, check the system. The following problems are the most com-
mon ones and you can solve them. If the system doesn't work, even after having checked it, call
the nearest CLIMMA Assistance Centre. If there isn't any on the telephone directory or if the tele-
phone directory is not updated, call the Veco Service: +39.0362.35321 or consult the WEB page:
www.climma.it
6.1 - THE UNIT DOESN'T WORK.
Is the automatic switch snapped?
Reset the switch on the main board.
6.2 - THE FAN DOESN'T TURN.
Is the air-conditioner switched on?
Switch on the unit by means of the control panel.
Is the fuse burned?
After the necessary checks, replace the F1 fuse with another one with the same dimensions and
charge.
6.3 - THE COOLING IS NOT SUFFICIENT - CO, RC, EH VERSIONS.
Have you selected the correct operational mode?
Select on the panel the cooling mode (COOL) or AUTO (only for the digital model).
Have you correctly regulated the thermostat?
Regulate the temperature on lower values.
Is the fan speed too low?
Increase the fan speed or select the AUTO mode for the digital version.
Is the air circulation insufficient?
Check that there are no obstructions on the outlet or inlet grills and that the filter is cleaned.
Is the air filter dirty?
Clean or replace it.
Has the compressor been running only for short periods?
The high pressure switch device is snapped. Check the water circulation, the filter and the sea
water pump.
Doesn't the compressor run?
The high pressure switch device is snapped more than three times. Check the sea water circuit,
switch off and then switch on again the system by means of the panel. If this happens again, call
the Assistance Service.
6.4 - THE HEATING IS NOT SUFFICIENT - EH VERSION.
Have you selected the correct operational mode?
Select on the panel the heating mode (HEAT) or AUTO (only for the digital model).
Have you correctly regulated the thermostat?
Regulate the temperature on higher values.
Is the fan speed too high?
Decrease the fan speed or select the AUTO mode for the digital version.
10