General Characteristics - Cembre HT51 Bedienungsanleitung

Application range
Crimping force
Rated operating pressure
Dimensions
Weight
Recommended oil
Operating speed:
Safety
2.1) Setting
(Ref. to Figs. 1 and 2)
– Select the appropriate die set for the connector.
– Open the latch (21) and release the upper die holder (22).
– Insert one die into the upper die holder (22) and one die into the lower die support (20).
– Close the latch.
Ensure that the latch (21) and the upper die holder (22) are fully secured, otherwis damage
may occur during tool operation.
– Remove the handle restraint (01) to release the moveable handle (36).
– Insert the conductor into the connector.
– Locate the connector between the dies at the desired crimp position.
2.2) Die advancement
– Operate moveable handle (36) for die advancement. This fi rst stage rapidly closes the dies to the
connector (the automatic opening of the moveable handle allows the operation of the tool using
one hand, while locating the connector in the desired crimp position with the other).
Make sure that dies are exactly positioned on desired crimp point; otherwise, re-open dies fol-
lowing instructions as per § 2.5 and position the connector again.

1. GENERAL CHARACTERISTICS

Suitable for installing electrical compression connectors for
kN (sh ton)
bar (psi)
mm (inches) 380 x 130 (14.9 x 5.1)
kg (lbs)
AGIP ARNICA 32 or
SHELL TELLUS TX 32
or equivalent
The tool has a twin speed operation and automatically
switches from a rapid advancing speed of the ram to a slower
The tool is provided with a maximum pressure valve:
MPC1 gauge is available to check the correct
2. INSTRUCTIONS FOR USE
HT51
conductors up to 240 mm
50 (6)
600 (8,700)
2,75 (6)
more powerful crimping speed
setting of the valve
HT51-KV
2
(500 MCM)
386 x 130 (15.2 x 5.1)
3,0 (6.6)
TOTAL DIEKAN 1640
or equivalent
4