Atag WG8U Futura Gebrauchsanweisung Seite 21

assembly
(continued)
motormodule
Screw two screws (4.2 x 9.5) halfway into the rear holes (1)
in the motor module (see illustration).
Slide the motor module upwards in the mounting socket and
2
pull the motor module backward slightly so that it catches in
3
the mounting socket and remains suspended (2).
1 Fix the front two screws (4.2 x 9.5) as shown in the
illustration (3). Then tighten the rear two screws (2).
Make the necessary plug connections.
Fit the discharge duct.
GB 16
assembly
(continued)
lower telescopic pipe
Slide the lower telescopic pipe upwards over the motor
module (1).
Hold the pipe up by carefully pushing a pen or screwdriver
2
into the hole that has been made for this purpose in the front
of the motor housing (2).
1
fitting the hood
Fit the hood to the motor module. First hook the rear of the
hood into the motor module from underneath (1). Then push
4
the front upwards (2), so that the two bolts supplied (M5 x
12) can be screwed in (3). Level the hood using these bolts.
1
2 3
Make the plug connections in the hood.
Allow the lower telescopic pipe to drop (4) so that it slides
into the edge of the hood.
Put the filters in place and test the extractor hood.
GB 17