VOLTCRAFT 10050 Bedienungsanleitung Seite 4

Product overview
1
6
5
1 USB output
2 Micro-USB input
3 LED light
Charging the battery
Fully charge the built-in rechargeable battery before first use.
Ensure that the connected devices' specifications conform to the product's
specifications listed in the technical data section.
Do not short-circuit the USB ports.
• Remove the protective cap.
• Connect the Micro-USB plug with the Micro-USB socket.
• Connect the USB-A plug to a free USB port on a computer or a suitable USB power
adapter.
• The internal battery is now charging. The battery level indicator flashes during
charging.
• As soon as the internal battery is fully charged, all 4 LEDs of the battery level
indicator are lit permanently.
• Disconnect the cable from the product and the power source as soon as the
rechargeable battery is fully charged. The product is now ready for use.
If you only use the product occasionally, we recommend that you fully
charge the internal battery every three months in order to retain maximum
capacity.
Charging mobile devices
• Remove the protective cap.
• Connect your mobile device with one of the USB outputs.
The two USB outputs can provide a charging current of up to 3.4 A.
If both USB outputs are used at the same time, the total current consumption
of both connected devices may not exceed 3.4 A.
• If the charging process does not start automatically, press the on/off switch.
• Monitor the charging process.
• The product automatically switches off as soon as the mobile device is fully
charged.
• Remove the USB cable from the product and the mobile device as soon as the
charging process is complete.
1 2 3
4
4 Hanger
5 On/off switch
6 Battery level indicator
Battery level indicator
Press the on/off switch to display the charging status of the internal battery for
approx. 5 seconds.
Battery level indicator
LED flashes
LED light
Press and hold the on/off button for about 2 seconds to switch the LED light on or off.
Care and cleaning
• Disconnect the product from the connected devices before cleaning.
• Never use aggressive detergents, rubbing alcohol or other chemical solutions, as
these may damage the casing or cause the product to malfunction.
• Do not immerse the product in water.
• This product does not contain any components that require maintenance. Never
attempt to open or disassemble it.
• Use a lint-free cloth to clean the product. Do not press too hard on the housing, as
this can lead to scratch marks.
• Dust can be easily removed using a soft and clean long-haired brush.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste. Always dispose of the product according to the relevant
statutory regulations.
You thus fulfil your statutory obligations and contribute to the protection of
the environment.
Technical data
Input voltage/current ......................5 V/DC, 2 A
Output voltage/current ...................5 V/DC, max. 3.4 A (total)
Rechargeable battery ....................Li-ion, 10050 mAh
Protection type ...............................IP65
Operating/storage temperature .....+8 to +35 °C
Cable length ..................................30 cm
Dimensions (L x W x H) .................127 x 74 x 27 mm
Weight ...........................................248 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or capture in
electronic data processing systems) requires prior written approval from the editor. Reprinting, also in part, is prohibited.
This publication represent the technical status at the time of printing.
Copyright 2018 by Conrad Electronic SE.
Remaining capacity
<5 %
5 – 25 %
25 – 50 %
50 – 75 %
75 – 100 %
LED off LED on
*1601917_v1_0518_02_IPL_m_en