Pioneer XW-BTSP1-W Bedienungsanleitung Seite 10

Removing the built-in battery
1. Remove the speaker grill.
Remove the 4 Torx screws from the Front
Cabinet.
2. Remove the 10 screws to fix speaker bracket.
3. Remove 2 speaker connectors from PCBA.
Next, disconnect other 5 connectors on
PCBA.
4. Remove the 4 mounting screws for chassis.
5. Remove the 6 screws of battery cover plate.
6. Take the battery out from the bottom
cabinet.
TIPS
battery , do not pull on the device's
connectors or wires.
screwdriver between the battery and case,
and pry out the battery. Be careful not to scar
the battery with the tip of the screwdriver.
7. Use a piece of adhesive tape to tape the
battery connector to the side of the battery.
TIP
entire connector with adhesive tape and
fasten it to the battery's body.
CAUTION
placing the depleted Lithium-ion Polymer
battery into the recycling container of a
participating dealer.
- Do not remove any of the battery's vinyl
plastic covering.
- Do not cut the battery's wire or connector.
- Do not attempt to disassemble the
battery.
- If the battery's metallic terminal becomes
exposed, cover it entirely in electrical
insulating tape.
device, follow all local community rules and
ordinances regarding disposal.
10
Electrical tape