Setting High-Speed Sync In Ettl Mode; Multi Mode: Stroboscopic Operation - Walimex Pro Operator TTL Gebrauchsanleitung

7.8.2 Im Modus <A:B C> group A and B fire according to the flash ratio, and
group C fires at the same time without ratio.
The setting for A:B is the same as above.
Set up flash exposure compensation for group C: Briefly press the [Group] but-
ton; the triangle points to group C. Rotate the dial to set flash exposure compen-
sation for group C. Flash exposure compensation is adjustable from -3 to +3 in
1/3 precise increments.
Flash exposure
compensation
7.8.3 In <ALL> mode, the ratio is off for group A, B and C. All the groups fire
with the same flash output. Flash exposure compensation for group A, B and
C can be adjusted via the camera but cannot be adjusted via radio transmitter.
Notice
If you need more power, you may use more flashes.
51

7.9 Setting high-speed sync in ETTL mode

With certain Canon cameras, you can achieve sync speeds of up to 1/8000th
of a second. When photographers shoot outdoors in bright sunlight with a wide
open aperture, fast shutter speed can cut the ambient light, getting amazing
results.
Briefly press the <SYNC/CH> button and set the shutter speed to high-speed
sync <
Flash ratio

7.10 Multi Mode: Stroboscopic Operation

To achieve an ideal shooting effect, please only use a single light in stroboscopic
mode.
Select <Multi> mode: Press and hold the [MODE] button for 3 s, and set the
radio transmitter to <Multi>.
Select group: Briefly press the [GROUP] button to select group A, B or C.
the LCD panel.
High-Speed Sync
>.
High Speed Sync (FP flash) enables the flash to synchronize with all camera shutte
when you want to use aperture priority for fill-flash portraits.
MODE
GR/CH
MENU
H
OFF/ON
1
Press High Speed Sync Button
so that < > is displayed.
● If you set a shutter speed that is the same as or slower than the camera's maxim
will not be displayed in the viewfinder.
● With high-speed sync, the faster the shutter speed, the shorter the effective flash
● To return to normal flash, press <
● Multi flash mode cannot be set in high-speed sync mode.
● Over-temperature protection may be activated after 50 consecutive high-speed s
amount.
● "0.3"means 1/3 step, "0.7"means 2/3
step.
● To cancel the flash exposure
compensation, set the amount to
"+0".
2
Please use X1 series transmitter.
> button again. Then < > will disappe
- 35 -
52