Echo HCAA-2401A-LW Bedienungsanleitung Seite 20

Maintenance and care
1. Drive shaft
50-Hour Maintenance
1. Outer tube
2. Gearcase clamp bolt
3. Gearcase
4. Index bolt
1. Gearcase grease fittings
4. Pull the drive shaft from the outer tube, and wipe clean. Re-
coat with a thin coating 15 mL of grease.
5. Slide the drive shaft back into the outer tube, being careful
not to get dirt on the drive shaft.
6. Align the screw hole in gear case with the locating hole in
outer tube, install and tighten index bolt, and tighten gear-
case clamp bolt.
Gearcase lubrication
To perform this operation, first remove the gearcase from the out-
er tube as follows:
1. Clean dirt from grease fitting.
2. Loosen the gearcase clamp bolt.
3. Remove the index bolt from the gearcase.
Do not remove the D-shaped shim washer from the
gearcase clamp. The shim washer prevents damage
from overtightening the tube clamp bolt.
4. Slide the gearcase out of the tube. Using a grease gun,
pump urea-base grease (about 10 grams) into the grease fit-
ting on the gearcase.
5. Clean up excess grease, then reassemble the gearcase
onto the outer tube. Make sure the index bolt fits into the hole
on the outer tube. Securely tighten both bolts.
18
CAUTION