Scheppach HS720 Originalanleitung Seite 28

The restart of an engine that is already hot from the previous operation usually does not require use of the choke.
1. Open the fuel valve (B) to the right in the opening position.
2. Move the throttle lever (C) on a semi-open position.
3. Turn the ignition switch (E) to ON.
4. Then hold the reverse starter handle (D) and pull the cable out slightly until you feel resistance. Then pull the reverse
starter handle (D) in one swift movement and leave the cable to wrap back slowly. Do not allow the reverse starter
handle (D) to snap back.
After the engine starts, move the throttle lever (C) to full throttle position, so that the splitter can achieve its maximum
working force.
End of work
• Set the throttle (C) at the slow position to the stop position.
• Close the fuel shut-off valve (B).
• Observe general maintenance instructions.
Place the jack in the transport position and secure it with the locking lever.
The HS720/HS720B provides maximum safety thanks to its enclosed sawing area.
Prior to commissioning the device for the first time:
Cut off the cable ties on the tension springs. Open the protective cover (1) and mount the tension springs as displayed in
the image.
28 GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58