Training Of The Operator; Technical Data - Scheppach HS720 Originalanleitung

• Defective saw blades can cause injuries. Regularly inspect the structural integrity of saw blades.
• The operating instructions supplied with the special accessories must be observed and carefully read when Scheppach
special accessories are used.
Attention: risk of accident!
The wood must always be seated on both sides of the saw blade on the v-block of the rocker. (see arrows)
Caution Danger of accidents!
Wear safety shoes.
Accident risk!
Before commissioning instruction
manual read.

6. Training of the operator

• Forward the safety instructions to all people working on or with this machine.
• The minimum age for the operating person is 18 years. Trainees should be minimum 16 years of age, but are only
allowed to work with the machine under supervision.
• People running the machine should not be distracted.
• Keep children away from the to the net connected machine.
• Wear tight fitting clothes. Take off jewelry, rings and wristwatches.
• Observe all safety and hazard warnings on the machine and keep it in readable condition.
• Be careful at work: Danger of damaging finger(s) and hand(s) by the rotating cutting tool.
• Regular pauses must be observed during operation.
• Safety shoes and protective clothing must be worn during operation.

7. Technical Data

Article Number
Construction measurements:
Total length
Total width
Total height
Rocker support
Saw blade ø
Idle speed motor
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
HS 720
5905109901
mm
mm
mm
mm
mm
1/min 1400
Caution Danger of accidents!
To wear ear protection.
Wear safety glasses.
Attention!
Tool continues to run after
power disconnected!
Before any maintenance, cleaning
or repair work, disconnect the unit
from the power supply!
For engines equipped with an
internal combustion engine, dis-
connect the spark plug connector!
HS 720 HS 720B
5905109902 5905109903
1270
730
1130
670
700
1400 1400
GB 23