How To Use; Before Using For The First Time; Using The Kettle; Boiling Water - Silvercrest SWKS 2200 A1 Bedienungsanleitung

__RP100469_B6.book Seite 6 Donnerstag, 13. Februar 2014 3:52 15

5. How to use

DANGER! Risk of electric
shock!
• Only connect the device to an easily ac-
cessible wall socket whose voltage cor-
responds to the specifications on the
rating plate. The wall socket must contin-
ue to be easily accessible after the de-
vice is plugged in.
• Pull the mains plug|6 out from the wall
socket after every use.
• Remove all packing material.
• Check to ensure that all parts are pre-
sent and undamaged.
• Place the device on a dry, level, non-slip
surface.
6. Before using for the
first time
1. Fill the kettle|2 up to the marking
MAX 1.7L on the water level display|3
and heat the water (see "Using the kettle"
on page 6).
2. Pour the water out and rinse out the ket-
tle|2 with fresh water.
3. Repeat this process. Then it is safe to
use the device.

7. Using the kettle

DANGER! Risk of injury
through scalding!
• It is always necessary to close the lid|9
when heating water, as boiling water
may otherwise spray out!
• Do not open the lid|9 while the water is
boiling.
• Fill the kettle|2 only to the maximum fill-
ing level (MAX 1.7L), as boiling water
may otherwise spray out.
6
GB
• Do not bend over the kettle|2 when you
open the lid|9 and the contents are still
hot. There is a danger of being scalded
by escaping steam.
• The kettle|2 becomes very hot during
operation. Only touch it at its handle|7
and only use the release button|8 and
the on/off switch|5.
WARNING! Risk of material damage!
Never put alcohol, sugar or milk into the ket-
tle|2!
Water as foodstuff
Water is a very sensitive foodstuff and can go
bad due to germs forming. Please take note:
• Always use fresh drinking water in the
kettle|2.
• Pour water away, which has been
standing in the kettle|2 for longer than
approx. 1 hour.
• Do not reboil cooled down water.

Boiling water

1. Remove the kettle|2 from the device
base|4.
2. Press the release button|8 to open the
lid|9.
3. Fill the desired amount of fresh drinking
water into the kettle|2. Keep it upright
or place it on an even surface to be
able to read the water level display|3
correctly.
4. Close the lid|9, by pressing it down-
wards.
5. Place the kettle on the device base|4.
6. Insert the mains plug|6 into a wall sock-
et corresponding to the technical data.
7. Press the on/off switch|5 down, until it
lights up blue and locks into place.
8. The device automatically switches off as
soon as the water starts to boil.
9. Disconnect the mains plug|6 from the
wall socket.
10.Remove the kettle|2 from the device
base|4 and pour the water out.