Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DMX Linking
The WELL Pad will work with a DMX controller using a wireless DMX connection. A DMX Primer is available from
www.chauvetprofessional.com.
DMX Connection
The WELL Pad uses a wireless DMX data connection for its DMX personalities: 4Ch, 6Ch, 10Ch, HSV, and HSI. See the
User Manual for information about connecting and configuring the product for DMX operation.
Infrared Remote Control (IRC)
The WELL Pad is fully compatible with the Infrared Remote Control (IRC) from CHAUVET. For more information on the
IRC, download the User Manual from www.chauvetprofessional.com.
It may be necessary to turn the product off and on again when switching from W-DMX to IRC and vice
versa.
Wireless Operation
In optimal conditions, the WELL Pad can operate up to 300 m (900 ft) away from the W-DMX transmitter. The W-DMX
receiver in the WELL Pad must be paired with the W-DMX transmitter for wireless operation.
Initial Setup
1.
Turn the W-DMX transmitter on.
2.
Connect the W-DMX transmitter to a DMX controller.
3.
Place the WELL Pad within 300 m from the W-DMX transmitter.
4.
Turn the WELL Pad on.
Configuration
1.
From the WELL Pad's control panel, go to DMX Address.
2.
Select the start address, as with any other DMX compatible product.
3.
Go to Wireless Setting > Receive On/Off.
4.
Select On. (The Signal Strength Indicator will show a ? in front of the bars)
5.
Press the reset button on the W-DMX transmitter.
(The Signal Strength Indicator on theWELL Pad will show a ϟ in front of the bars for 3 seconds while a
connection is established.)
Product Pairing
If the WELL Pad has already been paired with the W-DMX transmitter, the Signal Strength Indicator in the middle of the
LCD screen will show the strength of the signal. In this case, the WELL Pad is ready to work in Wireless mode.
Pairing the WELL Pad and a new W-DMX transmitter
1.
From the WELL Pad's control panel, go to Wireless Setting > Receive Reset.
2.
Select Yes. The Signal Strength Indicator on the WELL Pad will show a ? in front of the bars.
3.
From the W-DMX transmitter, press <RESET> (the Signal Indicator on the transmitter will flash).
4.
Once the transmitter has found the WELL Pad, the Signal indicator on the W-DMX transmitter will illuminate
solid.
5.
The Signal Strength Indicator in the middle of the LCD screen on the WELL Pad will show the strength of the
signal.
W-DMX operation can be interrupted or inhibited by liquid masses between the transmitter and
receiver such as water, snow, or people. For best results, keep the area between the transmitter and
receiver clear of any liquid mass.
Storage Notes
•
Recharge the battery to full capacity before storing the product.
•
Store charged product(s) in a dry environment, away from direct sunlight.
WELL Pad QRG Rev. 1
QUICK REFERENCE GUIDE
EN
2
Werbung
Inhaltsverzeichnis
