Husqvarna ROYAL 50S Betriebsanleitung Seite 10

Starting & Stopping Royal 50S
Starting
1. Connect the spark plug
lead.
2. Move the Engine
Speed Control to the
FAST '+' position
before starting. (J1)
3. Pull the operator
presence control
(OPC) to release the
brake on the engine
and the blade.(J2)
4. Pull the recoil starter
fully towards you until
you feel the full
resistance, return the
handle slowly then pull
the handle firmly
towards you to its full
extent. (J3)
5. After the engine has
started, allow to run for
30 seconds before
commencing to use.
Engaging the Drive
1. Forward drive is
engaged and
disengaged with the
Powerdrive lever at the
top of the handle (J4).
2. Releasing the
Powerdrive Lever
stops the forward drive
automatically.
Stopping
1. Release the
powerdrive lever.
2. Release the OPC
lever.
Starting & Stopping Royal 50SE
Starting
1. Follow steps 1-3 for
the Royal 50S
2. Turn the key and hold
until the engine starts
(K). The key will
return to the original
position when
released.
3. If the engine fails to
start when you turn the
key your battery may need charging.
English - 5
USE - STARTING AND STOPPING
J1
engine
speed
control
-
+
J2
J3
recoil starter
J4
K
Engaging the Drive - See Royal 50S
Drive speed can be
altered with the drive
speed control. (L)
Stopping -
See Royal 50S
Please note:- Your Royal 50SE can be started
manually by following steps 1-5 in
Starting & Stopping Royal 50S
Key Start Only - During mowing, your engine
will recharge the battery
Starting & Stopping Royal 50S/BBC
(BBC - Blade, Brake , Clutch)
1. Follow steps 1 - 2 - 4 and 5 for the Royal
50S.
2. Pull the BBC arm to
the handle (M1).
3. While holding the BBC
arm, push forward
BBC control lever until
a click is heard (M2).
4. Release the BBC
control lever which will
return to its original
position.
5. Releasing the BBC
arm will stop the blade
from rotating.
Please Note:
Leaving the engine
running without the
blade rotating for an
extended length of time
could lead to the
engine overheating.
Engaging the Drive - See Royal 50S
Drive speed can be altered with the drive speed
control. (L)
Stopping
1. Release the powerdrive lever.
2. Release the BBC arm.
3. Move Engine Speed Control to the '-'
position.
L
drive speed
control
M1
M2