Disposal Of Your Old Appliance - Powerpeak FTM6716 Bedienungsanleitung

Exercises for the calves achilles tendon (8)
Place both your hands on the wall and support your full body weight. Then move your left and right
leg alternately backwards. This stretches the back part of the leg. Maintain this position for 30-40
seconds if possible.

DISPOSAL OF YOUR OLD APPLIANCE

1. When this crossed-out wheeled bin symbol is attached to a product it means the product is
covered by the European Directive 2002/96/EC.
2. All electrical and electronic products should be disposed of separately from the municipal waste
stream via designated collection facilities appointed by the government or the local authorities.
3. The correct disposal of your old appliance will help prevent potential negative consequences for
the environment and human health.
4. For more detailed information about disposal of your appliance, please contact your city office,
waste disposal service or the shop where you purchased the product.
Fault Code
Communication abnormal:
The control and computer
E1
has abnormal
communication after start
No Speed Wireless Sensor
Network: Can't receive the
E2 motor speed sensor
feedback above three
seconds.
The motor wire is not
connecting well
E3
Fault Description Fault Processing
The controller is not working and going into fault. The
machine cannot run, the computer shows fault code
"E1", and the buzzer will ring three times.
Possible Reasons: Communication obstructed between
controller and computer, please check the wire and
make sure the wire connects well and the wire without
any damage..
Stop and go into fault status, computer buzzer will ring 3
tones and shows fault code"E2". Other areas show
blank. After 10 seconds will go into ready mode, and can
restart.
Possible Reasons: Can't receive the motor speed sensor
feedback above three seconds, please check sensor plug
and motor connect wire and the controller.
top and go into fault status, computer buzzer will ring 3
tones and shows fault code"E3". Other areas show
blank. After 10 seconds will go into ready mode, and can
restart.
Possible Reasons：Check if the motor wire is connected
well and re-connect the motor wire well if not; check if
56