Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
PG-A10X
PG-A10X-SL
AN-A10T
Replacing the prism holder unit
1. Remove the two lock screws, and take the prism holder unit and the projection lens assembly out of the optical
unit.
2. Remove the four lock screws, separate the prism holder unit and the projection lens assembly from each other.
3. Replace the prism holder unit with new one. Take the above steps 1 and 2 in reverse order.
Note: Even if just one of the LCD panels is defective, it is necessary to replace the entire prism holder unit. Do not
replace just the defective LCD panel only.
2Projection lens lock screws
B-LCD panel
Prizm holder unit
Projection lens assembly
22
Optical unit
G-LCD panel
1Prizm holder unit lock screws
R-LCD panel
Werbung
Inhaltsverzeichnis
