Start Weighing; Tare Off Additional Weight; Tare - Seca 376 Bedienungsanleitung Und Garantieerklärung

Start weighing

Tare off additional
weight (TARE)
44 •
1. Check that there is no load on the scales.
2. Press the Start key.
The display will read
through all elements of the display.
The scales are ready for operation when the display
reads
If the device is being operated with a power supply
unit, the symbol
3. Place the baby on the scales.
4. Read off the measured result.
You can use the TARE function to prevent the weighing
result from being affected by an additional weight (e.g.
a towel or pad on the weighing surface).
hold
1. Place the additional weight on the scales.

tare

2. Hold down the arrow key (hold/tare) until "NET"
appears in the display.
3. Wait until the display stops flashing and is replaced
by
4. Place the baby on the scales.
5. Read off the measured result.
The additional weight has been automatically
NET
deducted.
6. To disable the TARE function, press the arrow key
(hold/tare) until "NET" no longer appears in the
hold
display or switch off the scales.
tare
se[A
0. 0 00
.
will appear in the display.
ATTENTION!
Incorrect measurement with force shunt
If an additional weight (e.g. large towel) is in
contact with the surface on which the scales
are standing, the weight will not be measured
correctly.
− Make sure that any additional weight is only
placed on the weighing surface of the scales.
0. 0 00
.
NOTE:
The maximum weight that can be displayed is
reduced by the weight of the objects already
placed on the scales.
and then quickly run