Operating Determinations - EuroLite DMX Scan Control 192 MK2 Bedienungsanleitung

Always plug in the power unit least. Make sure that the device is switched off before it is connected to the
mains.
Keep away from heaters and other heating sources!
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it
on immediately. The arising condensation water might damage your device. Leave the device switched off
until it has reached room temperature.
This device falls under protection-class III. The device must be operated with an appropriate power unit.
Always disconnect from the mains, when the device is not in use or before cleaning it.
Please note that damages caused by manual modifications on the device or unauthorized operation by
unqualified persons are not subject to warranty.
Keep away children and amateurs from the device!
There are no serviceable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.

3. OPERATING DETERMINATIONS

The DMX controller serves for operation of DMX-controlled light effect devices such as LED spot lights,
moving heads and scanners in discotheques or on stage. The controller provides 192 control channels which
can be assigned as desired to the control elements. The adjusted values can be memorized in 240
illumination scenes (8 scenes in 30 memory banks). 6 additional memory banks are available for
programming chases (sequences of scenes) with 240 steps each. The illumination scenes and chases may
run manually, sound-controlled or time-controlled. All settings of your light show can be conveniently stored
and archived on a USB memory device.
The device requires an operating voltage of 9-12 V, 300 mA direct current supplied by the included power
unit. The power unit is allowed to be operated with 100-240 V, 50/60 Hz alternating current. The unit was
designed for indoor use only.
Do not shake the device. Avoid brute force when installing or operating the device. When choosing the
installation spot, please make sure that the device is not exposed to extreme heat, moisture or dust. There
should not be any cables lying around. You endanger your own and the safety of others!
This device must never be operated or stockpiled in surroundings where splash water, rain, moisture or fog
may harm the device. Moisture or very high humidity can reduce the insulation and lead to mortal electrical
shocks. When using smoke machines, make sure that the device is never exposed to the direct smoke jet
and is installed in a distance of 0.5 meters between smoke machine and device. The room must only be
saturated with an amount of smoke that the visibility will always be more than 10 meters.
The ambient temperature must always be between -5° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters. The relative humidity must not exceed 50 % with an ambient temperature
of 45° C. This device must only be operated in an altitude between -20 and 2000 m over NN. Never use the
device during thunderstorms. Over voltage could destroy the device. Always disconnect the device during
thunderstorms.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Please use the original packaging if the device is to be transported. Never remove the serial barcode from
the device as this would make the guarantee void.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons! If this
device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.
31/56 00116794, Version 1.0