WABCO LEAKAGE FINDER 2.0 Betriebsanleitung Seite 23

Tests
Alternatively, the loudspeaker can be used.
The loudspeaker must be charged via a separate USB cable before it is put into operation.
A red LED lights up during charging. This goes out when the charging process is finished.
Please also refer to the supplied operating instructions.
– Plug the speaker's jack into the jack socket of the WABCO Leakage Finder 2.0.
– Activate the speaker by pressing the button on the back until the blue light is activated.
– Hold the tip of the structure-borne sound probe at a 90° angle on a non-moving part of the bearing
(e.g. shaft, hub, etc.).
– Note the maximum value in dBµV, which is shown on the display.
Please make sure that during the measurements the bearings are always loaded with the
same revolutions and the same load as in the previous tests or as in the comparative bearing.
NOTICE
Damage to the probe connector
The probe connector may be damaged if turned while disconnecting it from the WABCO Leakage
Finder 2.0.
– Press the button to release the connector.
– Pull the probe out of the slot straight and carefully.
i
i
i
i
EN
23