WABCO LEAKAGE FINDER 2.0 Betriebsanleitung Seite 21

Tests
CAUTION
Danger of hearing impairment
Adjusting the headphones too loudly can cause hearing damage.
– Turn the volume down on the device before putting on the headphones.
– Observe the manufacturer's original operating instructions and the valid instructions for working
safely with hearing protection in noise areas.
Using the headphones:
– Connect the connecting cable to the headphones and the WABCO Leakage Finder 2.0.
When connecting the headphones, make sure that both connectors (on the WABCO Leakage Finder
2.0 and on the headphones) are fully plugged into the jack socket.
– Put on the headphones.
Alternatively, the loudspeaker can be used.
The loudspeaker must be charged via a separate USB cable before it is put into operation.
A red LED lights up during charging. This goes out when the charging process is finished.
Please also refer to the supplied operating instructions.
– Plug the speaker's jack into the jack socket of the WABCO Leakage Finder 2.0.
– Activate the speaker by pressing the button on the back until the blue light is activated.
– Guide the WABCO Leakage Finder 2.0 along the seals.
– Follow the acoustic and visual signals to determine the leakage.
Ö An increasingly louder sound and an increasing level on the display indicate untightness.
– Adjust the volume using the arrow buttons
experience.
– Minimise the sound intensity of the transmitter as soon as you notice an ultrasonic signal through the
closed components (e.g. glass, doors, etc.) or on the display.
– Restart your test.
NOTICE
Damage to the probe connector
The probe connector may be damaged if turned while disconnecting it from the WABCO Leakage
Finder 2.0.
– Press the button to release the connector.
– Pull the probe out of the slot straight and carefully.
i
i
, if necessary, to improve the listening
EN
21