Preparation Before Operation - Mitsubishi Electric MS-GD80VB Bedienungsanleitung

NAME OF EACH PART
Remote controller
COOL & HEAT type (MSH series)
Signal transmitting section
Operation display section
ON/OFF (operate/
stop) button
Open the front lid.
(This diagram shows an overall view.)
VANE button
(Horizontal vane button)
I FEEL COOL
Operation select button
ECONO COOL
ECONO COOL button
WIDE VANE button
(Vertical vane button)
RESET button
(Refer to PREPARATION BEFORE OPERATION for details.)
4
˚C ˚C
CLOCK CLOCK
AMPM AMPM
AMPM AMPM
TOO TOO
ON/OFF
WARM COOL
In case of COOL ONLY type
(MS series)
Temperature buttons
In case of COOL ONLY type
(MS series)
˚C
CLOCK
I FEEL COOL
AMPM
AMPM
FAN DRY
TOO TOO MODE
ON/OFF
WARM COOL
Fan speed control button
FAN STOP
Off-timer button
VANE START
HEAT DRY
On-timer button
MODE WIDE VANE HR.
HR.button
MIN.button
LONG MIN.
(Time set buttons)
RESET CLOCK
CLOCK set button
LONG button

PREPARATION BEFORE OPERATION

Auto restart function
I
These models are equipped with an auto restart function. If you do not want to use this function,
please consult the service representative because the setting of the unit needs to be changed.
Auto restart function is ...
When the indoor unit is controlled with the remote controller, the operation mode, the set temperature and the fan speed are
stored in the memory. If a power failure occurs or the main power is turned off during operation, "Auto restart function" sets
automatically to start operating in the same mode as the one set with the remote controller just before the shutoff of the main
power. (Refer to page 6 for details.)
Indoor unit
I
Insert the power supply plug into the power outlet and/or turn the breaker on.
WARNING:
Remove dirt from the power supply plug and insert the plug securely.
If dirt adheres to the plug or insertion is incomplete, it may cause a fire or an electric shock.
I
Check the type of air conditioner.
Type Model Name
COOL & HEAT MSH-GD80VB
COOL ONLY MS-GD80VB
NOTE:
This operating instructions manual has different contents for the COOL & HEAT type air conditioner and
COOL ONLY type.
Follow the appropriate instructions for each type of air conditioner.
Remote controller
I
The remote controller used for the COOL ONLY type air conditioner is different from the one used
for the COOL & HEAT type as shown in the illustrations to the left.
I
Use the remote controller provided with the unit only.
Do not use other remote controller.
Check the difference of operation mode.
Type Operation Mode
COOL & HEAT (I FEEL...), (COOL),
COOL ONLY (I FEEL...), (COOL),
NOTE:
Only the remote controller for the COOL & HEAT type air conditioner is illustrated as an example in this operating
instructions manual.
(DRY), (HEAT)
(DRY), (FAN)