Monitoring The Current Channel; Vox Mode - AUDIOLINE Power PMR 46 Bedienungsanleitung

PMR 46 GB_041212_dtp 04.12.12 12:33 Seite 11

Monitoring the current channel

Normally the walkie-talkie will not pick up very weak signals. But you can
monitor the current channel for all sounds.
+

VOX mode

VOX = Voice operated transmission.
In VOX mode your handset will transmit whenever it detects your voice (or
other noise) without the PTT button having to be pressed.
When turning on the VOX mode you will set the sensitivity. At the highest
level (3), the handset will pickup softer noise (including background noise);
at the lowest level, it will pick up only quite loud noise.
When you start to speak, there is a slight delay before the walkie-talkie
starts to transmit. If no noise is detected for approx. 2 seconds the
transmission will be cut off.
VOX operation is not recommended if the PMR will be used in a noisy or
windy environment.
4 x
/
Operating the Walkie-Talkies
Press the menu key and the key ▼simultaneously.
RX appears on the display.
Press the menu key again to stop monitoring.
Press the menu key 4 times.
VOX is displayed and „OF" flashes on the display.
Select the sensitivity (3 Levels) using the up/down keys
and confirm by pressing the PTT button.
As long as the handset is in VOX mode, VOX will display
steadily on the display.
For deactivating the VOX mode select "OF" instead of a
sensitivity and confirm by pressing the PTT button.
GB
11