Waeco CR50 Bedienungsanleitung Seite 45

CoolMatic
NOTICE!
A
Disconnect the refrigerator and other electric loads from the battery
before connecting the battery to a quick charging device.
Overvoltage can damage the appliance electronics.
For safety reasons the refrigerator is equipped with an electronic system to
prevent the polarity being reversed. This protects the refrigerator against re-
versed polarity when connecting to a battery and against short circuiting. To
protect the battery, the refrigerator switches off automatically if the voltage is
insufficient (see table below).
Cut-off voltage
Cut-in voltage
Connecting the refrigerator to AC power (accessory)
NOTE
I
The CR140 and all US versions are available in DC/AC version
only. Without using a rectifier, these refrigerators can be operated
using a 110-240 V~ current source, in addition to a 12 or 24 Vg
current source.
You can connect the refrigerator to AC power if you use a rectifier
(accessory):
 110 - 240 V: MPS-35
DANGER! Danger of electrocution
D
 Never handle plugs and switches with wet hands or if you are
standing on a wet surface.
 If you are operating your refrigerator on board a boat with a
mains connection of 230-V from the land, you must install a re-
sidual current circuit breaker between the 230V mains supply
and the refrigerator.
Seek advice from a trained technician.
EN
Installing and connecting the refrigerator
12 V
10.4 V
11.7 V
24 V
22.8 V
24.2 V
45