Noise Emission; Content Of Delivery; Machine Description; Transport And Installation - Jet JMD-3 Gebrauchsanleitung

Mains 230V ~1L/N/PE 50Hz
Output power 1 kW (1,35 HP) S1
Reference current
Extension cord (H07RN-F
Installation fuse protection

4.2 Noise emission

Acoustic pressure level
(according to EN ISO 11202):
Idling at maximum speed
LpA 75,8 dB (A)
The specified values are emission
levels and are not necessarily to be
seen as safe operating levels.
As workplace conditions vary, this
information is intended to allow the
user to make a better estimation of the
hazards and risks involved only.

4.3 Content of delivery

13mm drill chuck with arbour MT3
Draw bar M12
Drilling and milling guard
Operating tools
Operating manual
Spare parts list.

4.4 Machine Description

Fig 1
A.... Fine feed hand wheel
B..... Down feed handles
(with tapping control buttons
fwd-/rev.)
C....Head tilt 90° index
D.....Main switch
E.....Z-axes slide-lock
F.....Fine feed engagement knob
G.....X-axis hand wheel
H.....Y-axis slide-lock
3 A
3x1,5mm²
I......Z-axis hand-wheel
16A
J......Y-axis hand-wheel
K......X-axis slide-lock
L..... Chuck guard
M.....Quill lock handle
N.... Drill depth stop display
O.... Emergency stop button
P.... Spindle control knobs
Q....Spindle speed display
R..... Draw bar cover
5. Transport and start up

5.1 Transport and installation

The machine will be delivered in a
closed crate.
For transport use a forklift or hand
trolley. Make sure the machine does
not tip or fall off during transport.
The machine is designed to operate in
closed rooms and must be bolted to
the cabinet stand or a solid work
bench.
Make sure the machine cannot tip!
For packing reasons the machine is
not completely assembled.
5.2 Assembly
If you notice transport damage while
unpacking, notify your supplier
immediately. Do not operate the
machine!
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces with
petroleum, diesel oil or a mild solvent.
Attach the crank handles to the hand
wheels (G, I, J Fig 1).
Mounting machine to stand or solid
workbench.
Unbolt the lathe from the shipping
crate bottom.
Use heavy duty fibre belt for lifting the
machine off the pallet.
5
Caution:
The machine is heavy (165 kg)!
Assure the sufficient load capacity
and proper condition of your lifting
devices.
Never step underneath suspended
loads.
Carefully place the machine onto the
cabinet stand or a solid work bench.
Bolt together machine and cabinet
stand or workbench (see bolt whole
pattern Fig 2).
Fig 2
Make sure the machine cannot tip!
Fig 3
Use a machinist's precision level to
make sure that the machine table is
level.
Loosen mounting bolts, shim and
tighten mounting bolts if needed.
The machine must be level to be
accurate.