Before Assembly; Inserting / Replacing Rechargeable Batteries - FLORABEST Z29544 Montageanleitung

Before assembly

Q
The solar panel installed in the article converts sunlight into electrical
energy and stores it in a NiMh battery. Switches on the light as it
begins to get dark. The in-built light-emitting diodes are a very
long-life and energy-saving light source. The light duration de-
pends on the amount of sunlight, the angle of light on the solar
panel and the temperature (the battery capacity is temperature-de-
pendent). A vertical angle of light at temperatures above the freez-
ing point is ideal. The battery does not achieve maximum capacity
until after several charge and discharge cycles.
Inserting / replacing
Q
rechargeable batteries
j
Set the ON / OFF switch
j
Screw the nuts
j
Remove the cover
out of the lamp
damage the solar element
NOTE: The solar element
compartment
j
Insert the rechargeable batteries
ment . Ensure correct polarity. This is indicated in the battery
12
compartment
j
Insert the solar element
j
Replace the cover
place by tightening the nuts
8 GB/IE/CY
to "OFF".
13
anti-clockwise off the cover
9
and take the solar element
1
(see Fig. B). Make sure that you do not
7
10
10
.
12
.
12
back into the lamp
10
back onto the lamp
1
9
and/or its cable.
is connected to the battery
into the battery compart-
11
7
again in a clockwise direction.
.
1
carefully
10
.
7
and fix it in