Operation Without The Remote Control Unit - Technibel MRAF98C5T Serie Bedienungsanleitung

HOW TO ADJUST THE FLAP DIRECTION
MRAF-MPAF MODELS
Zone «A»
for cooling and dehumidifyng
KPAF MODELS
« A »
« B »
Zone «A»
for cooling and dehumidifyng
Zone «B»
for heating
CAUTION
Set vertical vanes to the front position during
COOLING/DRY operation if humidity is high.
If the vertical vanes are set to the left-most or right-most
position, condensation will form around the air outlet
and drip off.
CAF MODELS
Zone «B»
for heating
« A »
« B »
40°
(ONLY MRAF-MPAF-KPAF
MODELS)
Zone «A» for cooling
and dehumidifyng
Zone «B»
for heating
OPERATION WITHOUT THE REMOTE
CONTROL UNIT
If you have lost the remote control unit or it has troubles,
follow the steps below.
1. WHEN THE AIR CONDITIONER IS STOPPED
If you want to turn on the air conditioner push the operation
selector with a pen to select the desired mode (COOL or
HEAT).
NOTE
The air conditioner will start in HIGH fan speed.
The temperature setting is 25°C for cooling mode and
21°C for heating mode.
2. WHEN THE AIR CONDITIONER IS RUNNING
If you want to turn off the air conditioner push the operation
selector with a pen until the OPERATION lamp is turned off.
NOTE
Power failure during operation.
In the event of power failure, the unit will stop. When the
power is resumed, the unit will restart automatically after 3
minutes.
MRAF-MPAF MODELS
KPAF MODELS
CAF MODELS
OPERATION
SELECTOR
9
OPERATION
SELECTOR
OPERATION
SELECTOR
GB