Operation Without The Remote Control Unit; Care And Cleaning - Technibel MPW1B5XA Bedienungsanleitung

HOW TO ADJUST THE FLAP DIRECTION
GB
OPERATION WITHOUT THE REMOTE
CONTROL UNIT
If you have lost the remote control unit or it has troubles,
follow the steps below.
1. WHEN THE AIR CONDITIONER IS STOPPED
If you want to turn on the air conditioner push the operation
selector with a pen to select the desired mode (COOL or
HEAT).
NOTE
The air conditioner will start in automatic fan speed
and flap sweep operation. The temperature setting is
25°C for cooling mode and 21°C for heating mode.
2. WHEN THE AIR CONDITIONER IS RUNNING
If you want to turn off the air conditioner push the operation
selector with a pen until the OPERATION lamp is turned off.
NOTE
Power failure during operation.
In the event of power failure, the unit will stop. When the
power is resumed, the unit will restart automatically after 3
minutes.
MPW MODELS
KPSW MODELS
Zone «A»
for cooling and dehumidifyng
Zone «B»
for heating
OPERATION
SELECTOR
OPERATION
SELECTOR
CWX MODELS
OPERATION
SELECTOR

CARE AND CLEANING

WARNING
● Maintenance operations must be carried out by specially
trained personnel.
● For safety, be sure to turn the air conditioner off and also
to disconnect the power before cleaning.
Do not pour water on the indoor unit to clean it. This will
●
damage the internal components and cause an electric
shock hazard.
CASING AND GRILLE
Clean the casing and grille of the indoor unit with a vacuum
cleaner brush, or wipe them with a clean, soft cloth.
If these parts are stained, use a clean cloth moistened with
a mild liquid detergent.
CAUTION
Never use solvents, or harsh chemicals when cleaning the
●
indoor unit. Do not wipe the plastic casing using very hot
water.
Some metal edges and the vanes are sharp and may
●
cause injury if handled improperly; be especially careful
when you clean these parts.
MPW MODELS
The air intake grille can be removed in order to wash it
with water.
Removing and remounting the air intake grille
• With the air intake grille open all the way, grip both
arms with your hans and pull toward you to remove.
• To remount, hold the air intake grille roughly horizontal
and push it in until the arm shafts fit into the indenta-
tions in the main unit, then fit the grille into place.
Washing the grille with water
• Clean the grille gently using a soft sponge, or the like.
Then wipe away any remaining moisture.
• Neutral detergent may be used to remove stubborn
dirt. Then rinse thoroughly with water and wipe away
any remaining moisture.
9
Arm
Air intake grille