LEITZ iLAM TOUCH A3 Bedienungsanleitung Seite 9

To ensure the best possible
lamination and to avoid any damage
to the laminator, please take the
following precautions:
• Laminating pouches are made
of two sides linked to each other.
Never laminate with only one side
of a laminating pouch.
• Always insert laminating pouches
into the unit with the folded side
first. Do not insert a laminating
pouch until the previous laminated
document has been removed.
• Always insert the pouch in the
centre of the laminator entry area.
• Never laminate empty pouches.
Always insert a document into the
pouch when laminating.
• Do not cut the pouch prior to
lamination. Trim the pouch to size
after lamination.
• Do not laminate heat-sensitive,
wet, wavy or crinkly materials.
• Do not laminate materials thicker
than specified in this manual.
• Do not laminate metal objects.
• The lamination process is
irreversible. Please keep this in
mind when laminating unique
pieces.
• Do not pull or push the pouch and
do not switch off the laminator
during normal lamination.
Unpack and check the
contents
2
A iLam Laminator
B Mains cord/plug
C Quick Start Guide and Safety
Instructions
Use
How to laminate a document
1. Set the laminator
a stable surface (e.g. table)
close to a mains outlet. Ensure
there is sufficient space behind
the laminator so the laminated
document is not blocked and can
easily be removed.
2. Connect the mains cord
mains socket and laminator
3. Fold out the input
trays.

4. Set the rear switch
position to turn on the laminator.
The On/Off button
blue and you will hear a beep.
5. Press the On/Off button
The On/Off button
flashing blue. The laminator heats
up. As soon as the On/Off button
lights steadily blue again

and you hear beep, the working
temperature has been reached.
6. Insert the document into the
laminating pouch. Align it to the
pouch's folded side as close as
possible and ensure even margins
on the left and right. Pouches that
are too large can be trimmed to
size after lamination.
Warning! Lamination is
permanent. Before laminating
unique pieces, test the process
with a similar item. Always insert
smaller objects in the middle of
the input tray so that they are
recognized by the thickness
sensor.
7. Insert the pouch with the folded
side first straight into the input
tray until it gets pulled in.

2
3
up on

with

.

and output

in the "I"

will light

.

will start
