LEITZ iLAM TOUCH A3 Bedienungsanleitung Seite 11

Problem
During lamination the
pouch gets stuck in the
front part of the laminator.
During lamination the user
switches off the device or
the mains power fails or
the device is otherwise
disconnected from mains.
When pressing the
Reverse button, the pouch
is not being reversed but
transported further.
The laminator always
runs at the same speed
regardless of the thickness
of the material.
Disposal
The symbol on the packaging indicates that the packaging is made of
PAP.
Cause
Glue deposits on the
roller / heat reaction of
pouch.
Power failure.
Normal behaviour because
the pouch has already
left the front part of the
laminator.
Thickness sensor
defective.
4
Solution
Press reverse button as
soon as possible. The
pouch is driven out through
the input tray. Assist the
process by carefully pulling
at the pouch. As soon as
the pouch has left the front
sensor area, ensure the
pouch is clear of the entry
area to prevent the pouch
from being pulled in again.
To laminate another item,
switch the device on again.
Clean the rollers after any
pouch jam as described in
section "Maintenance and
care".
After re-starting the
laminator, automatic
reverse is activated for 30
seconds to drive out the
pouch through the input
tray. As soon as the On/Off
button lights blue, you can
laminate again as usual.
Clean the rollers after any
pouch jam as described in
section "Maintenance and
care".
None.
Please let the laminator
be inspected by customer
service.