Technical Data - GUTMANN Redonda Bedienungsanleitung

en
To change the lamp (bulb including reflector),
lift the holding ring (c) out of the hood using
a screw driver.
Then loosen the plug of the bulb (a) plug
and remove it from the holder. To do so, the
split washer (b) must be pressed together
and removed from above.
Install the new lamp in the reverse
sequence.
Dysfunctions
Please refer to our customer service if
- the extractor hood produces too much
undefined noise and the control of the
exhaust air path reveils no faults;
- the supercharger works faulty;
- the circuit operates invalid.
Please indicate your type of extractor hood
and the series number. These informations
are mentioned on the type sheet which is
situated inside the hood on the filter.
Disposal
Packaging
The packaging of the appliance is recyclable.
It is made up off cardboard and polyethylene
foil (PE). Please dispose these materials in
a environmentally aware, responsible way
and in accordance with the regulations of
your local authority.
Extractor hood
Your local community will be able to advise
you on an environmentally compatible
disposal of sorted out household
appliances.
Enviromental information
This appliance is labelled in accordance with
the European Directive 2002/96/EG
conceming used electrical and electronic
appliances (waste electrical and electronic
equipment - WEEE). The guideline
determines the framework for the return and
recycling of used appliances as applicable
throughout the EU. Please ask your dealer
about current means of disposal.

Technical data

Connection mains:
230 V / 50 Hz, max. 500 watt
Lighting: halogen
Type G/4 21520 (12 V, 35 watt)