GUTMANN Sombra Montageanleitung Seite 26

en
hoods) and the electrical connection in such
a manner that connecting the hood will be
simple later on. Please ensure that only as
much of the exhaust hose is protruding from
the upper hose shaft as will be required for
further installation.
Place the hood in position (adjustable height
of the overall hood height 680-830mm / 800-
950 mm). Please drill three attachment holes
with a hole diameter of 6mm.
A drilling stencil is attached to the upper tower
with which the hole position can be
determined exactly (remove the template
after drilling, as well as any shavings). Now
screw the machine screws into the screw
anchors and allow them to protrude by
approximately 20mm. Attach the washers and
nuts to the machine screws. Do not tighten
the nuts; instead allow them a distance of
approximately 6mm to the ceiling. Now please
install the upper tower by placing it on the
nuts and securing it by turning. Now tighten
the nuts and protect the tower against twisting
by tightening another screw to the ceiling
through the 10mm hole in the upper tower.
Now attach the hose to the hood posts, create
an electrical connection to the power supply
and please allow the low voltage wiring to the
light diodes to protrude from the upper tower
for later connection. The electrical connection
to the hood must be made for external
blowers. Now place the hood module in the
upper part and attach it with the hexagonal
screws (M5) through the previously drilled
attachment holes. Now place the under tower
on the installed upper tower and fasten it
provisionally with tape. Now place the glass
plate on the hood module, lead the glass
holder through the hole in the pane and attach
a