GGP ITALY SPA RIDER 63 Gebrauchsanweisung Seite 51

EL63 model:
4.4a SPEED CHANGE LEVER
This lever has five positions for
the three forward gears, the neu-
tral position «N», and reverse
«R».
– To change gear, press the
pedal (4.2) halfway down and
move the lever as per the indi-
cations on the label.
WARNING!
Reverse must be engaged when
the machine has stopped.
ELV63 model:
4.4b SPEED CHANGE SHIFT
This shift is used to engage
wheel traction and modulate for-
ward machine speed.
– Forward machine speed grad-
ually increases by moving the
gear shift towards «F»; reverse
(at set speed) is engaged by
moving the gear shift towards «R».
– Always gradually move the gear shift to change speeds,
without moving the gear shift too fast.
4.4a
N
2 3
R 1
4.4b
F
N
R
– When starting with the engine off, gradually engage
wheel drive using pedal 4.2.
IMPORTANT
Only move the gear shift when the
engine is running and pedal 4.2 is released.
WARNING!
Reverse must be engaged when
the machine has stopped.
4.5 CUTTING HEIGHT ADJUSTING LEVER
There are five positions for this
lever, shown as «1» to «5» on the
plate, which correspond to various
cutting heights from 3 to 7.5 cm.
– To go from one position to anoth-
er, move the lever sideways and
put it back in one of the stop
notches.
4.6 LEVER ENGAGEMENT AND BRAKE OF BLADE
The lever has two positions, as
shown on the plate:
«A» = Blade disengaged
«B» = Blade engaged
– If the blade is engaged when
4.5
4.6
B
A
EN 13