Dmx Mode - JB Systems POWERED T-BAR 4 CHANNELS DMX Bedienungsanleitung

3. F + PRESET: for each of the indicated options, the following parameters can be adjusted:
Fade time: (0 till 10 seconds), display shows: F00 - - F99
•
Dimming level: (0 till 100 %), display shows: D00 - - DFF
•
Speed: (1/60 step per second till 20steps/sec.), display shows: A01 - - A99
•
Preheat of the lamps: (0 till 25 %), display shows: E00 - - E25
•
Programs: (1 till 16), display shows: P01 - - P16
•
4. F + CH 1: choose the direction of the channel output: left to right or right to left,
display shows: L - - R - -
5. F + D/S: choose between normal dimming (0 to 100 %), display shows: NOA or
SWITCHPACK – gradation (if dimming level is greater than 50 %: FULL-ON, when smaller
than 50 %: STAND-BY). display shows: CAO.
F + SIGNAL + RESET: resets the whole system. The unit will return into its initial
6.
condition.

DMX MODE

To put the unit in DMX MODE: press F + SIGNAL. The display shows "IN". The unit will now be
used as a DMX DIMMER PACK.
1. DMX addressing:
press the channel button that you would like to give an address: the corresponding LED will
blink. Use the UP and DOWN buttons to select the desired DMX address for that channel.
By pressing the same channel button again, the blinking LED indicator will fade out and the
entry is confirmed.
2. F + MODE: no application in DMX MODE.
3. F + PRESET: for each of the indicated options, the following parameters can be adjusted:
Fade time: (0 till 10 seconds), display shows: F00 - - F99
•
Dimming level: (0 till 100 %), display shows: D00 - - DFF
•
Preheat of the lamps: (0 till 25 %), display shows: E00 - - E25
•
4. F + CH 1: choose the direction of the channel output: left to right or right to left,
display shows: L - - R - - .
5. F + D/S: choose between normal dimming (0 to 100 %), display shows: NOA or
SWITCHPACK – gradation (if
smaller than 50 %: STAND-BY). display shows: CAO.
6. F + SIGNAL + RESET: resets the whole system. The unit will return into its initial
condition.
All inputs are registered when the LED stops blinking and when "IN" is shown on the display.
DMX Bar 4
dimming level is greater than 50 %: FULL-ON, when
3