Master Mode - JB Systems POWERED T-BAR 4 CHANNELS DMX Bedienungsanleitung

ENGLISH
Equipment
This cabled T-bar is completely equipped with following components:
4-channel chaser
•
4 + 1 plugs (Schuko or Euro)
•
4 fuses 6,3 A / 250 V
•
1 male XLR-connector (DMX IN)
•
1 female XLR-connector (DMX OUT)
•
1 stereo-jack connector 6,35 mm (for foot control)
•
8 screws ( 8 mm) + wings for attachment of the projectors
•
1 powercable (1 m 50) with plug 16 A
•
Introduction
The light modulator has 2 possibilities: MASTER or DMX.
When working in MASTER-mode, the modulator has 6 options:
•
manual dimmer, manual program, auto program, hold sound, program sound and auto
sound. All options working on music use the internal microphone for sound detection.
Also, the T-Bar working as MASTER can control other compatible units or DMX DIMMER
•
PACKS.
When used in DMX-mode, the built-in DIMMER PACK can be controlled by an external DMX-
•
controller. All 4 channels can receive a different DMX-address.
Following functions are also built in this T-Bar: STAND-BY, FULL ON and PREHEAT.
•
The following instructions will guide you in working with this unit.

MASTER MODE

1. Press F + SIGNAL SELECT: the display marks "OUT", while the LED of MASTER is lit.
Now, the unit is used as a MODULATOR-CHASER.
2. Press F + MODE to choose between the 6 options indicated in the introduction.
Manual dimmer: press the button of the channel you wish to dim, the corresponding
•
LED will blink. Adjust to the needed level, using the UP and DOWN buttons.
Manual program: the 16 programs will be played, you can change the speed.
•
Auto program: the 16 built-in programs will be randomly played.
•
Hold sound: modulator, based on the rhythm of the music (bass, mid, treble)
•
Program sound: the chosen program (1 ~ 16) will be played based on the rhythm of
•
the music.
Auto sound: the 16 programs will be played to the rhythm of the music.
•
DMX Bar 4 2