Cocraft NLL01 Bedienungsanleitung Seite 5

Using the laser line
Horizontal laser line
For horizontal alignment
the aluminium supporting surface
(2) must be facing downward.
Align the laser spirit level horizontally using the bubble vial for horizontal projection (4).
Note: Horizontal alignment using the laser spirit level is only possible on the surface
against which the wall holder is placed. A laser line projected onto an adjoining wall
will not necessarily be horizontal.
Vertical laser line
For vertical alignment the aluminium
supporting surface (2) must be facing to
the side.
Align the laser spirit level vertically using
the bubble vial for vertical projection (3).
The adjustment knob on the wall
holder can be used for setting
the laser spirit level to an angle of
your choice for applications such as
projecting lines parallel to stairs for
hanging picture frames.
Using the laser dot
Used on a tripod (sold separately),
the laser spirit level can also be used
to mark points at the same height on
multiple walls. The height should also be
checked manually by measuring. Bear
in mind that the setting will be altered
if the tripod or spirit level is knocked or
jolted.
5