Testing The Detector - Velleman PIR451B Bedienungsanleitung

 All modifications of the device are forbidden for safety reasons.
Damage caused by user modifications to the device is not covered
by the warranty.
 Only use the device for its intended purpose. Using the device in
an unauthorised way will void the warranty.
 Damage caused by disregard of certain guidelines in this manual
is not covered by the warranty and the dealer will not accept
responsibility for any ensuing defects or problems.
4. Features
 automatic day/night identification
 adjustable light sensitivity and ON-timer
5. Installation
Installing the detector is very easy: screw the detector into lamp
socket and screw the lamp into the detector's socket. Make sure to
cut off the mains power before installing/removing the detector
and/or lamp.
6. Operation
6.1

Testing the Detector

1. Test the detector at the point of time you feel the lamp needs to
be switched on.
2. Turn the LUX knob fully clockwise; turn the TIME knob fully anti-
clockwise.
3. Switch on the power. The detector needs a warm-up time of
± 30 seconds before it will switch on the connected lamp. When
no signal is detected, the lamp will switch off after
± 10 seconds.
4. Turn the LUX knob fully anti-clockwise. The lamp should switch
off.
6.2 Setting the Detector
1. Turn the LUX knob until the lamp switches on.
2. Now, set the switch-off delay with the TIME knob going from
± 10 seconds to ± 5 minutes.
V. 01 – 24/03/2016
PIR451B
4 ©Velleman nv