Installation; Safety; Instructions, Standards And Regulations; Safety Information - STIEBEL ELTRON SOL 27 Premium W Bedienung Und Installation

7.

Safety

Only qualified contractors should carry out installation,
commissioning, maintenance and repair.
7.1

Instructions, standards and regulations

Note
Observe all applicable national and regional regulations
and instructions.
7.2

Safety information

WARNING Injury
!
A solar collector generates heat when exposed to sunlight
or other types of light. This leads to collector connectors
getting very hot, even when they are not filled. There
is a risk of burns and the collector suffering damage.
Cover the collectors with opaque material until they are
fully installed. It is advisable to leave collectors in their
packaging until they are installed.
Damage to the appliance and environment
Be careful not to drop the collector. Be careful not to
drop any objects on the collector. Do not step onto the
collector.
Damage to the appliance and environment
Do not leave the collector unsecured. It the collector falls
down, the glass may break.
8.

Equipment description

The collector is fitted with a full area aluminium absorber with
highly selective coating. The connections are routed out of the
side. The hydraulic connection between collectors is made without
any tools by means of a plug-in connector system.
A prismatic single pane safety glass cover with anti-reflex coating
protects the absorber. Operating the collector with the prepared
heat transfer medium (see "Specification") provides the essential
frost protection. The collector casing is made from seawater-
resistant aluminium.
The "SOL 27 premium S" collector is used both for the installation
of several collectors on end next to each other, and for installation
across above each other.
The "SOL 27 premium W" collector is designed for the installation
of several collectors across next each other.
8.1

Standard delivery

- Flat-plate collector
- Cleaning cloth