Before Initial Use; Assembly Of The Cordless Sweeper; Charging The Battery - Silvercrest SABD 3.6 Li A1 Bedienungsanleitung

GB
ATTENTION! PROPERTY DAMAGE!
IE
Charge the appliance only with the supplied mains adapter/charger
►
CY
(type SABD 3.6 Li A1-2)!
Only this cordless sweeper may be charged with the supplied battery
►
charger; the charger is not suitable for other batteries.
Never try to recharge non-rechargeable batteries.
►

Before initial use

■ Remove all packaging materials from the ap-
pliance. Including the plastic safety catch that
secures the switch 4 from accidental activation
during transportation.

Assembly of the cordless sweeper

Attach the handle 2:
■
–
put the 3 handle elements 2 together so
that the oval locking studs w click into the
holes.
–
Press the grip 1 into the handle so that the
locking stud on the grip 1 protrudes into
the hole in the handle 2.
–
Push the assembled handle 2 with the
locking stud w into the holder 3 on the
appliance.
Push the dirt container 8 onto the appliance
■
so that the release knob 7 clicks into place.

Charging the battery

To ensure that the battery reaches its full perfor-
mance potential, it is necessary to charge the bat-
tery for around 5 hours before the fi rst use. Further
charges will take up to 5 hours depending on the
discharge level of the battery.
With a fully charged battery, the appliance provides
an operating time of 50 minutes before recharging
will be again required.
4
ATTENTION! MATERIAL DAMAGE!
► Use only the supplied charger.
► Operate the appliance only with the built-in
battery.
► Never attempt to remove the battery to
recharge it.
► Do not attempt to open the battery housing
or dismantle the battery. This will destroy it.
1) To charge the battery, ensure that the cordless
sweeper is switched off .
Switch it off using the switch 4 if required.
NOTE
Do not use the cordless sweeper when it is con-
nected to the charger.
2) Open the dust cover that closes the charging
socket 5.
3) Insert the plug of the battery charger into the
charging socket 5 of the appliance and then
attach the mains plug to a mains power outlet.
4) While the battery is charging, the charge in-
dicator 6 lights up red. If this is not the case,
check the connectors and whether the cordless
sweeper is switched off .
5) Once the battery is fully charged, the charge
indicator 6 lights up green. You can now use
the appliance with full power again.
6) First unplug the charger from the mains power
socket and then the charger plug from the
charging socket 5 on the appliance.
7) Close the charging socket 5 with the dust cover.
SABD 3.6 Li A1