adiva AD3 200 Betriebsanleitung Seite 87

BRAKING
• Avoid unnecessary braking , use rear and front wheel brakes simultaneously when braking
• Slow down and use engine break to assist in long downward slopes, do not brake constantly or brakes will overheat and possibly fail
• Avoid applying pressure on the brake lever when riding, brakes may overheat and braking efficiency will be reduced
• Throttle down when braking to a complete stop Never apply brakes suddenly on wet and slippery roads, slow down and brake early to avoid
skidding and falling
• Apply more pressure on the front brake than the rear brake when slowing down, too much pressure on the rear brake may cause the vehicle
to pull to one side
• Check the Brake reservoir regularly to ensure Brake fluid is above the "MIN" mark
• Use only High quality Brake fluid DOT 4 for replacement or top-up, DO NOT MIX WITH OTHER GRADES OR USE ALTERNATIVES!
• Have your authorised ADIVA Dealer check your brake during periodic maintenance to ensure the brake pads have sufficient padding to
activate the brakes. If you encounter a 'metallic' noise during braking, bring your vehicle for inspection immediately
Caution: The parking brake (not available in some countries) will not hold the AD3 upright in a parking position, the
side stand or centre stand is required to park the vehicle
Rear Brake
Parking Brake ( not available
in some countries
CAUTION!
DO NOT USE the parking
brake to slow down or stop
the vehicle while riding!
Front Brake
Foot pedal: front and rear brake simultaneously.
12
Foot Brake Pedal
approx. 60/40 (60% front)
Not available in some countries