Philips RQ1145 Bedienungsanleitung Seite 19

2 Place the shaver body in the holder behind the two clips (1) and
press it down until it locks into place (2).
, The display shows that the shaver is charging (see chapter
'The display').
3 Press the on/off button on the Jet Clean System to start the cleaning
program.
The shaver display stops showing the charging indication.
,
,
,
which takes a few minutes.
,
automatically switches on and off several times and moves up and
down.
, During the second phase of the cleaning program, the shaver is
This phase takes approx. 2 hours. The shaver stays in this position
until the end of the program.
, After the cleaning program, the charging indication appears on the
shaver display (see chapter 'The display').
Note: If you press the on/off button of the Jet Clean System during the cleaning
program, the program aborts. In this case, the cleaning or drying light stops
Note: If you remove the adapter from the wall socket during the cleaning
program, the program aborts. The holder remains in its current position.
When you put the adapter back into the wall socket, the holder moves to the
highest position.
-
starting position.
-
ENGLISH
19