Removing The Rechargeable Battery; Guarantee And Support; Guarantee Restrictions - Philips HP6581 Bedienungsanleitung

Problem Possible cause
The epilator does The socket used
not work. to charge the
epilator does not
work.
The rechargeable
batteries are
empty.
The travel lock is
active.

Removing the rechargeable battery

Note: We strongly advise you to have a professional remove the rechargeable
battery.
Only remove the rechargeable battery when you discard the appliance.
Make sure the battery is completely empty when you remove it.
1 Check if there are any screws in the back or front of the appliance.
If so, remove them.
2 Remove the back and/or front panel of the appliance with a
screwdriver. If necessary, also remove additional screws and/or parts
until you see the printed circuit board with the rechargeable battery.
3 If necessary, cut the wires to separate the printed circuit board and
the rechargeable battery from the appliance.
Removing the disposable battery
To remove the disposable batteries, see the appropriate section in
the user manual.

Guarantee and support

If you need information or support, please visit www.philips.com/
support or read the separate worldwide guarantee leaflet.

Guarantee restrictions

Cutting units are not covered by the terms of the international guarantee
because they are subject to wear.
Troubleshooting
This chapter summarises the most common problems you could
encounter with the appliances. If you are unable to solve the problem with
the information below, contact the Consumer Care Centre in your country.
Solution
Make sure the socket you use to charge the epilator is live.
The charging light goes on to indicate that the epilator
is charging. If you connect the epilator to a socket in a
bathroom cabinet, you may need to switch on the light in
the bathroom to make sure the socket is live.
When the charging light lights up red continuously, the
batteries are empty and you need to charge the epilator for
approx. 1 hour. Note: You have to charge the epilator fully
before first use.
To deactivate the travel lock, press and hold the on/off button
for 3 seconds until the speed lights flash white 2 times.
You can also connect the epilator to the mains with the
adapter to deactivate the travel lock.
ENGLISH
19