Overheat Protection - Philips HP6581 Bedienungsanleitung

Note: When you use shaving foam or gel, clean the shaving head during and
after each use with water to ensure optimum performance.
8 When you have finished shaving, switch off the appliance and clean
the shaving head according to the instructions in chapter 'Cleaning
and maintenance'.
9 Put the trimming comb on the shaving head when you store
the appliance.
Trimming with the comb
Use the shaving head with the comb attached to trim your hairs in the
bikini line to a length of 3 mm. You can also use the comb to pretrim long
hairs (longer than 10 mm) on the underarms or legs.
1 Press the release button (1) and remove the epilating head from
the epilator (2).
2 Put the shaving head on the appliance and press it until it snaps home.
3 Put the comb on the shaving head.
4 Follow steps 3 to 8 in section 'Shaving the underarms and bikini line'.

Overheat protection

This function helps to prevent overheating of the appliance.
Note: To avoid overheating of the appliance, do not press it too hard onto
your skin. The appliance works best when you move it over your skin without
excessive pressure.
If the overheat protection is activated, the appliance switches off automatically
and the charging light and the speed lights flash red for 30 seconds.
You can deactivate the overheat protection by letting the appliance cool
down and then switch it on again.
Note: If the charging light flashes red again, the appliance has not yet cooled
down completely.
ENGLISH
11