Safety Information - Fluke 337 Anleitung

33x
Calibration Information

Safety Information

To avoid possible electric shock or personal injury, and to avoid possible damage to the Meter
or the equipment under test, adhere to the following practices:
•
Avoid working alone so assistance can be rendered.
•
Never use the Meter on a circuit with voltages higher than 600 V or a frequency
higher than 400 Hz fundamental. The meter may be damaged.
•
Do not use the Meter or test leads if they look damaged.
•
Use extreme caution when working around bare conductors or bus bars. Contact
with the conductor could result in electric shock.
•
Read the instruction card and safety sheet before use and follow all safety instructions.
•
Use the Meter only as specified in the instruction card; otherwise, the Meter's safety
features may be impaired.
•
Use caution when working with voltages above 60 V dc or 30 V ac. Such voltages
pose a shock hazard.
•
Before using the Meter, inspect the case. Do not use the Meter if it is damaged. Look for
cracks or missing plastic. Pay particular attention to the insulation around the connectors.
•
Verify the Meter's operation by measuring a known voltage. Do not use the Meter if it
operates abnormally. Protection may be impaired. When in doubt, have the Meter serviced.
•
Do not apply more than the rated current or voltage, as marked on the Meter.
•
Use the proper terminals, function, and range for your measurements.
•
Do not operate the Meter with the case (or part of the case) removed.
•
When servicing the Meter, use only specified replacement parts.
International Electrical Symbols
The following international symbols appear in this document and on the Meter.
N10140
2
WWarnings and Precautions
Risk of electric shock
Risk of danger. Important Information. See manual.
Equipment protected by double or reinforced Insulation
Battery
Conforms to CSA C22.2 No 1010. 2.032-96
Conforms to EU directives
Earth
DC measurement
AC measurement
Conforms to relevant Australian standards
Conforms to UL 3111-1 and UL 3111-2-032
Inspected and licensed by TÜV Product Services