Removing The Stokke® Izi Go™ By Besafe; Removing And Refitting The Cover; Cleaning Instructions - BESAFE Stokke iZi Go Gebrauchsanweisung

Removing the Stokke® iZi Go™ by BeSafe®
• Remove the shoulder belt from the shoulder belt hook at the rear side.
• Release the belt from the buckle in the car and remove the belt from the hip belt
hooks.

Removing and refitting the cover

Removing the cover
• Pay attention when you remove the cover, as fitting the cover is done in the
opposite way.
• Take off the headrest and the baby cushion.
• Open the zippers. Do not remove the harness straps from the hooks in the seat.
• Take off the complete cover by pulling it carefully from the foam.
Refit the cover
• Pull the harness straps through the openings in the cover and close the zippers.
• Pull the buckle through the crotch strap cover and pull the hole for the central
adjuster over the central adjuster.
• Fix the cover at all sides by putting it carefully between the foam and seat shell.

Cleaning instructions

The covers of the Stokke® iZi Go™ by BeSafe® must be washed in accordance with
the instructions on the inside of the covers. Clean harness by hand with water and
mild soap.
Stokke® iZi Go™ by BeSafe®
UK 17