Renkforce 754389 Bedienungsanleitung Seite 52

Example 4: Operating mode „Single-User" with quick input
0000 *
00 #
0 32 #
 32 #
2 654 #
42 #
52 #
72 0 #
*
When activating the relay, „
whole user code does not have to be entered. After input of the two figures,
don't forget to push the diamond button.
When the relay is deactivated, however, the whole user code „
has to be entered!
For the access lock, input of „
the diamond key) are enough.
When deactivating the access lock, the entire code „
entered!
52
Call programming mode with the master code (basic
setting ex works „0000"), the yellow LED is lit perma-
nently
Attention - if another master code is already programmed,
it must be used, of course!
Use operating mode „Single-User" (pre-set at delive-
ry)
Attention - if the operating mode „Multi-User" was
activated first, this will delete all codes and pre-settings
(except for the master code)!
Programme master code to „3289"
Programme user code to „8321"
Programme code for access lock to „6854"
Use toggle operation with quick input
Access lock is to work in toggle operation at correct
code (the access lock is activated or deactivated at
every input of the code); with quick input
Code lock is locked for 15 minutes after 10 wrong code
inputs
Terminate programming mode; then the yellow LED
flashes slowly (standby)
3#
" is already accepted as user code. The
6#
" (the first two figures of the code and
32
654
" has to be
"